:o i just purchased my first sewing machine but cannot figure out how to thread.it is a brother LS-2125i
any advice on this?
thanks::

Do you have a manual for it? Or does is have numbered marking on top?

My brother also has some arrows guiding the path of the thread. I woudl definitley check the manual too!!! Once you get it the 1st time correctly, you will prob have it forever :thumb

:dizzy: i think i may have figured it out,but now the thread breaks and it skips stitches.any advice?
God Bless:thumb

adjust your tension. start at 5. If the bobbin side is leaving loops, then tighten the tension. If the thread is breaking, then loosen the tension

(I think....)

HTH

You have to make sure that the thread is long enough when you start sewing and you have to make sure the needle has gone all the way up and then down a little when you want to stop. Otherwise the bobbin thread and the spool thread get tied in a knot underneath.

So when you stop sewing, turn the wheel so your needle goes up and then down a little and then pull your garment out.

When you start to sew make sure your thread is atleast 5 inches long trailing behind the machine.